When the security monitoring equipment is installed, what steps need our attention? Today, let's take a look at it.One, security monitoring power supply problemsOften the equipment fault caused by the power problem, the power supply line or supply voltage is incorrect, the power is insufficient, the transmission line of the power supply system appears short circuit, open circuit, instantaneous overvoltage and so on. What we need to pay attention to here is that due to power supply error or instantaneous overvoltage will cause equipment damage, so before power supply, installation must be strictly and carefully check and check, can not be taken lightly.Second, security monitoring wiring problemSurveillance cameras installed wiring, according to distribution of area and building design, as far as possible according to the actual situation of the scene point layout, minimize the monitoring blind Angle, after a certain point, you can start to carry on the wiring, when carries on the wiring, each monitoring can be used as a a computer to layout, according to the standard of network wiring way to wiring, monitoring will be simpler.Iii. Security monitoring and heat dissipationAs is known to all, the working temperature of electronic devices directly determines their service life and stability, especially the heat dissipation of surveillance cameras. In order to keep the working temperature of electronic products' components within a reasonable range, in addition to ensuring that the temperature of the equipment's working environment is within a reasonable range, it is also necessary to conduct heat dissipation treatment.Four, security monitoring lightning insulationIn case of outdoor surveillance cameras, it is necessary to set up lightning pins and use independent grounding pipelines to isolate the power and image signals of monitoring equipment, so as to avoid interfering with power supply and damaging the circuit. Lightning rod should be installed above the camera, lightning rod point downward 45-60 degrees of virtual three-dimensional cone range, is the camera's safety range, lightning rod in the installation, should be isolated from the fixed camera steel structure insulation.There are still many things we need to know when installing monitoring. If you want to know more about security monitoring, please continue to pay attention to us.

Household burglar alarm is widely used in the home security system, more and more home security services into the community, villas and thousands of families.In the home security system, some people choose to find local security service providers to install home security alarm, and some hands-on ability is willing to install their own.What installation method does installation of home network alarm equipment have?1. Location.The installation position of burglar alarm directly affects the actual effect of burglar alarm.If a burglar alarm is installed in the wrong place, not only will it fail to work, but it will cost nothing to reinstall it.Burglar alarm is suggested to be hung in the middle of all detectors to facilitate signal carrying and avoid bad channels.As the burglar alarm is a high-frequency electronic product, it is easy to be disturbed by the magnetic field of large home appliances.So everybody installs network alarm in the home, when choosing a position, stay away from home appliance as far as possible.Second, choose your materials.For the home network alarm equipment, the choice of host is very important, the pros and cons of the host determines the safety factor of the home security system.Third, hide.The main purpose of installing a networked alarm and video surveillance system in your home is to prevent it.In the so-called "know yourself and know your enemy", internet-connected alarm devices in your home can be easily damaged by thieves if they are installed in too prominent a place.The following is about the home network alarm installation of some matters needing attention.I hope I can help you.